Seven subject areas, each tied to a task
The magazine is organised by the work a reader actually faces, not by product lines. Each area below describes what it covers and which checks you can run yourself before you commit to a method.
There is no search box, filter panel or account behind these areas. You move between them through the published pages, and the contact page is the only place where a message can be saved for the owner, after separate consent.
Renovation and repairs
Surfaces, doors and fittings. Guides start with diagnosis: measuring a gap with a feeler gauge, watching how a slab moves through a heating season, checking whether a hinge has pulled loose before the plane comes out. The least destructive fix is described first, with dust extraction and door support noted where they matter.
Painting old plaster
Breathable finishes for lime and gypsum walls. A drop of water and a scratch test tell you more about an unknown substrate than any label. Mineral silicate, lime wash and clay paint are compared against standard dispersion products, with notes on alkalinity, primer choice and a two-coat schedule.
Tools judged by criteria
A cordless drill is assessed on torque under load, chuck runout, whether spare batteries will still exist in five years, and how easily a trigger or gearbox can be serviced nearby. Voltage figures are treated as advertising, not as evidence.
Woodwork by hand
Flattening a glued-up bench top with a No. 5 and a straightedge, reading winding sticks under raking light, and sharpening a bevel-edge chisel on waterstones from 1000 to 8000 grit. The emphasis sits on observation and patience rather than expensive tooling.
Step-by-step guides
Where a method is long enough to need a sequence, it is written out in order, with the safety notes placed at the step where they apply rather than collected at the end. Workshop planning for a narrow basement follows the same pattern: lighting, dust and power before the larger machines.